Introduction to precautions for the operation of electric pipe beveling machine

The pipe cold cutting and bevelling machine is a specialized tool for chamfering and beveling metal pipes that need to be beveled before welding through cold cutting. Unlike flame cutting, polishing, and other operating processes, it has disadvantages such as non-standard angles, rough slopes, and high working noise. It has the advantages of simple operation, standard angles, and smooth surfaces.

There are three types of energy sources for cold cutting pipe beveling machine: electric, pneumatic, and hydraulic.

So today we will mainly explain the electric split frame pipe cutting and beveling machine. When using the electric pipe bevel cut, we need to pay attention to the following.

1) When placing the beveling machine, it must be placed flat and securely fixed to prevent movement during use.

2) When clamping the pipe onto the beveling machine, be careful not to collide with the cutting tool. When clamping the pipe firmly, leave a gap of 2-3mm between the pipe end and the cutting edge to prevent excessive tool insertion at once. When working, open the other joint on the frame to avoid simultaneous feeding.

3) To prevent the pipe from shaking and cutting the knife during pipe cutting, three central pulleys are used to block the pulleys and make slight contact at the maximum outer diameter of the pipe. When the groove is not too tight, the center of the pipe should be perpendicular to the cutting plane of the groove machine, slowly feed, and add coolant to cool the tool.

4) After the beveling machine is fed, it should be kept in its original position and rotated a few more turns to make the bevel smooth. After the operation is completed, move the tool holder outward, detach it from the cutting surface, and then remove the pipe.

5) The cooling system should be kept clean to prevent impurities and iron filings from seeping into and blocking the nozzle of the oil circuit.

6) After using the equipment, it is necessary to do a good job of maintenance and upkeep.

7) The cooling system should be kept clean to prevent impurities and iron filings from seeping into and blocking the nozzle of the oil circuit.

8) After using the equipment, it is necessary to do a good job of maintenance and upkeep.

For further insteresting or more information required about Edge milling machine and Edge Beveler. please consult phone/whatsapp +8618717764772
email:  commercial@taole.com.cn